Some Common Questions about Emergency Safety Shower And Eye wash Station

Question: What temperature is required for water?

Answer: The ANSI standard recommends that the water should be “tepid”. The ANSI 358.1-2004 appendix defines tepid waster as water temperature between 60° F -100° F ( 16 ° C-38 ° C). In locations where the temperature would below -0 ° C, anti- freeze should be considered. Normally auto-drain type or heater is installed. In locations where temperatures reach scalding levels from heat or exposure outside, scald protection valves or cooler must be installed.

Question:  Which areas may require emergency safety eyewash stations?

Answer: Work areas and operations that may require these devices include:

•      Battery charging areas

•      Laboratories and schools

•      Spraying operations

•      High dust areas

•      Hazardous substances dispensing stations

•      Marine shipping vessels & offshore platform

•      oil, gas, chemical, petrochemical area and so on

•      electrical factories

Question: Do I really need to test (activate) plumbed eyewashes weekly?

Answer: Yes, testing of plumbed units is required to ensure a flushing fluid supply is available when needed. Flushing helps clear the supply line of any sediment buildup and minimizes microbial contamination due to sitting water.

A comprehensive inspection should be conducted at least once a week to verify the reliability and effectiveness of the device, ensure effective emergency use in the event of an accident, and provide reliable personal safety and health protection.

Warning: Emergency use is only allowed in the event of an accident. Cleaning and use are strictly prohibited in daily life. Regulations and inspections should be established to prevent violations or frequent use of hand washing tools, which may cause product malfunction and unexpected accidents.

Question: How often do I need to clean and maintain my portable self-contained eyewash?

Answer: Portable eyewashes that mix potable water and preservative should be cleaned and refilled per the manufacturer's instructions, which typically is every four to six months.